Cisco 300-115 Exam With Updated Exam Questions – [Jan-2018 Dumps]

This Cisco Certified Network Professional Routing and Switching 300-115 exam required skills and knowledge if you want to pass 300-115 exam. Implementing Cisco IP Switched Networks 300-115 exam dumps is designed in a way that it cover all the key points of actual 300-115 exam. Braindumps4cisco provide you latest exam questions that realy provide you assistance in you actual Network Security 300-115 exam. There are four basic domains to be measured by this exam are Professional, and .

♥♥ 2018 NEW RECOMMEND 300-115 Exam Questions ♥♥

300-115 exam questions, 300-115 PDF dumps; 300-115 exam dumps:: https://www.dumpsschool.com/300-115-exam-dumps.html (364 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-115 Dumps Exam Questions and Answers:

Question: 21

Refer to the exhibit.

A multilayer switch has been configured to send and receive encapsulated and tagged frames. VLAN 2013 on the multilayer switch is configured as the native VLAN. Which option is the cause of the spanning-tree error?

A. VLAN spanning-tree in SW-2 is configured.
B. spanning-tree bpdu-filter is enabled.
C. 802.1q trunks are on both sides, both with native VLAN mismatch.
D. VLAN ID 1 should not be used for management traffic because its unsafe.

Answer: C

Question: 22

A network engineer must improve bandwidth and resource utilization on the switches by stopping the inefficient flooding of frames on trunk ports where the frames are not needed. Which Cisco IOS feature can be used to achieve this task?

A. VTP pruning
B. access list
C. switchport trunk allowed VLAN
D. VLAN access-map

Answer: C

Question: 23

What percentage of bandwidth is reduced when a stack cable is broken?

A. 0
B. 25
C. 50
D. 75
E. 100

Answer: C

Question: 24

Refer to the exhibit.

Which set of configurations will result in all ports on both switches successfully bundling into an EtherChannel?

A. switch1 channel-group 1 mode active switch2 channel-group 1 mode auto
B. switch1 channel-group 1 mode desirable switch2 channel-group 1 mode passive
C. switch1 channel-group 1 mode on switch2 channel-group 1 mode auto
D. switch1 channel-group 1 mode desirable switch2 channel-group 1 mode auto

Answer: D

Question: 25

Refer to the exhibit.

How can the traffic that is mirrored out the GigabitEthernet0/48 port be limited to only traffic that is received or transmitted in VLAN 10 on the GigabitEthernet0/1 port?

A. Change the configuration for GigabitEthernet0/48 so that it is a member of VLAN 10.
B. Add an access list to GigabitEthernet0/48 to filter out traffic that is not in VLAN 10.
C. Apply the monitor session filter globally to allow only traffic from VLAN 10.
D. Change the monitor session source to VLAN 10 instead of the physical interface.

Answer: C

Question: 26

Refer to the exhibit.

A network engineer wants to analyze all incoming and outgoing packets for an interface that is connected to an access switch. Which three items must be configured to mirror traffic to a packet sniffer that is connected to the distribution switch? (Choose three.)

A. A monitor session on the distribution switch with a physical interface as the source and the remote SPAN VLAN as the destination
B. A remote SPAN VLAN on the distribution and access layer switch
C. A monitor session on the access switch with a physical interface source and the remote SPAN VLAN as the destination
D. A monitor session on the distribution switch with a remote SPAN VLAN as the source and physical interface as the destination
E. A monitor session on the access switch with a remote SPAN VLAN source and the physical interface as the destination
F. A monitor session on the distribution switch with a physical interface as the source and a physical interface as the destination

Answer: B,C,D

New Updated 300-115 Exam Questions 300-115 PDF dumps 300-115 practice exam dumps: https://www.dumpsschool.com/300-115-exam-dumps.html

         

Facebook Comments